Skip to site menu Skip to page content

Assembly and Maintenance Procedure for Bondura 3.3

By Bolt Norge


Assembly Procedure

Preparations:

Remove any burr. Clean the support.

Align the bolt hole. The middle section must line up with the support on each side. Use a jack or hoist if necessary. If the bolt is hammered into a hole where the bearing and the support does not line up, the bolt may be damaged.

For full instructions, please download this free white paper.

Enter your details below to view the free white paper

By downloading this whitepaper, you acknowledge that GlobalData may share your information with our white paper partners/sponsors who may contact you directly with information on their products and services.

Visit our Privacy Policy for more information about our services, how GlobalData may use, process and share your personal data, including information on your rights in respect of your personal data and how you can unsubscribe from future marketing communications. Our services are intended for corporate subscribers and you warrant that the email address submitted is your corporate email address.

Related Content